Revolabs Fusion™ Wireless Microphone System- Tandberg Edge 75/85/95
MXP Setup Guide
NOTES AND CAUTIONS:
This setup guide will guide you through the steps needed to properly connect a
Revolabs Fusion System to a Tandberg Edge 75/85/95 MXP video codec.
1. Connecting the Cables
2. Configuring the Edge MXP Video Codec
Note: It is important to carefully follow these instructions in order and completely.
Otherwise your Fusion System and/or the video codec may not function properly.
Please read through these instructions completely before proceeding. Contact Revolabs
technical support if you have any questions.
Requirements for connecting systems:
1. Revolabs Fusion 4 or 8 microphone system
2. Tandberg Edge 75/85/95 MXP video codec
3. QTY 1 XLR male to XLR male cable
4. Qty 2 RCA-RCA male cable
5. Amplified speakers
NOTE: IMAGES OF SET UP SCREENS ARE DEFAULT SETTINGS FROM TANDBERG AND ARE PART OF THE
TANDBERG MXP ADMINISTRATOR’S GUIDE © MAY 2008
Configuring the Edge 75/85/95 MXP Video Codec
CONFIGURING THE AUDIO MENUS OF THE EDGE MXP VIDEO CODEC
1.
2.
3.
Go to AUDIO SETTINGS
Select INPUTS
Confirm that MIC 1 is ON
4.
5.
Adjust the audio Input Type Level if necessary (recommend +0dB)
Speak into the Revolabs microphones that are connected to MIC 1.
The audio meter should peak at about 5dB for normal speech.
6.
7.
Return to previous menu and select OUTPUTS
Confirm that Out1 is ON
8.
Adjust the audio Output Type Level if necessary (recommend +0dB)
9.
Return to previous menu and select ECHO CONTROL
10.
Enable MIC 1 Echo Canceller (ON)
11.
12.
Return to previous menu and select AUDIO LEVELING (AGC)
Turn MIC Audio Leveling (AGC) OFF
NOTE: You must use your Fusion remote control to control the room
volume for both the audio and video conference calls. Adjusting the
volume in the video codec will cause echo.
|