SALEEN SPEEDLAB
QUARTER WINDOW
KIT
INSTALLATION MANUAL: 2005 Mustang
P/N: 10-8002-C12167A
Saleen Performance, Inc. 76 Fairbanks Irvine, CA 92618 949-597-4900
Saleen Speedlab Quarter Window Kit
Installation Guide for 2005 Mustang
Thank you for buying the Saleen Speedlab Quarter Window Kit for the 2005 Mustang.
We appreciate your business, and we hope you enjoy your product.
For your benefit, please read the following instructions completely and thoroughly before
attempting to install the quarter window kit. Many questions we have received from
customers about the installation of our products could have been easily solved by
information listed in the accompanying installation guide. We want you to enjoy the
product in its fully functional state, and reading this tutorial is a great first step to getting
you on your way to a more rare and better handling Mustang.
Again, thank you for choosing Saleen!
3
Obtain the following tools:
•
•
Urethane Primer (CR Laurance Cat # PWR4P)
Pneumatic gun (Cox# 61006-20 Trent 20 oz.)
• Narrow Urethane Gun Tip
•
•
Urethane (CR Laurance Cat # PWR615HV)
Paint thinner
• Masking tape
Obtain the following parts:
Part Number
Description
Qty.
06-1101-C09948C
06-1101-C09949C
QUARTER WINDOW FRAME LH
QUARTER WINDOW FRAME RH
1
1
4
Order of Operations:
1. Using paint thinner, spray surfaces of
quarter window frame that will be
bonded to the rear quarter panel
window, and wipe those surfaces
until they are clean and dry. Also
clean the quarter window with glass
cleaner. Wipe both surfaces dry.
(Figures 1 & 2)
2. Apply urethane primer (see p. 4) to
the outer edge of the window (Figure
2) and the quarter window frame.
3. Tape off the entire outline of the window
(beginning of tape-off shown in Figure
3). The tape should go all the way up to
the groove around the window, but not
into the groove. (This is to make sure
the urethane does not get on the car)
4. With the narrow tip on the pneumatic
gun (see p. 4), apply urethane (see p. 4)
to the groove on the bond-surface of the
quarter panel window (Figure 4).
Figure 1
Figure 2
Figure 3
Figure 4
5
5. The bead of urethane should be of the
size shown in Figure 5, with the bead
up against the outer wall of the
groove and away from the inner wall
(to prevent seepage of urethane onto
the window surface).
6. Check for seepage of urethane on the
window pane, and wipe clean.
Cleaning any urethane seepage right
away will make the job easier and the
final product more attractive; be
careful not to disturb the window
panel piece.
7. Tape quarter window frame onto
body and allow 24 hours to set before
removing tape or checking frame
secureness (Figure 6).
Outer groove wall
Figure 5
Inner groove wall
Figure 6
6
|
Pyramid Technologies Car Amplifier PB444X User Guide
Sakar Digital Camera 14097 User Guide
Samson Home Theater System SXD3000 User Guide
Samsung Stereo System HT Z110 User Guide
Samsung Video Games Sch a310sa User Guide
Sangean Electronics Stereo System SR 2 User Guide
Sanitaire Yard Vacuum SC5700 User Guide
Sanyo Projector PLC XC56 User Guide
Sanyo Telephone CLT OHE40 User Guide
Sceptre Technologies Flat Panel Television E248 User Guide